LG Washer Error Code LE — Motor Locked / Overloaded
What this means
The LE error code on LG washers indicates the motor is unable to turn the drum. This is often caused by overloading the washer, a failed rotor position sensor (hall sensor), or a problem with the stator or main control board. It can also appear if the drum is physically jammed.
Alternate codes: LE1
Step-by-step fix
4 stepsReduce the load size
Open the washer and remove about half the laundry. Overloading is the most common cause of the LE error. Restart the cycle with a smaller load.
LG washers are high-efficiency — they use less water and are more sensitive to overloading than traditional washers.
Reset the washer
Unplug the washer for 10 minutes to allow the motor to cool and the control board to reset. Plug it back in and try running a cycle. The LE error can be triggered by a motor overheating from strain.
If the motor was overheated, giving it time to cool completely before restarting prevents further damage.
Check the rotor position sensor (hall sensor)
Remove the back panel of the washer. Locate the hall sensor on the stator assembly (a small component with a wire connector). Disconnect and test it with a multimeter — it should have a resistance of approximately 13–15 ohms between the two outer terminals.
The hall sensor is the most common part to fail when an LE error appears on LG washers.
Inspect the stator and rotor
While the back panel is off, check the stator coils for burn marks or damage. Spin the rotor by hand — it should turn freely. If it's jammed, check for objects caught between the tub and drum.
A single shorted winding in the stator can cause the LE error code intermittently.
When to call a professional
If the rotor position sensor tests bad or the stator is damaged, these require partial disassembly and some electrical knowledge to replace. The main control board could also be at fault. A technician is recommended for diagnosis beyond the hall sensor.
Related error codes
Information compiled from manufacturer service manuals, official troubleshooting documentation, and appliance repair industry resources. This guide is for informational purposes only — always consult a qualified technician for complex repairs.
Learn more about our sourcesParts you may need
Rotor Position Sensor (Hall Sensor)
Part #6501KW2002A · $10–$20
Most common cause — test first
Links may earn us a commission at no extra cost to you. We only recommend parts relevant to this repair.