Maytag Washer Error Code F2 E2 — User Interface Communication Error
What this means
The F2 E2 error code indicates a communication failure between the user interface control board and the main control unit (ACU). This can result from a loose ribbon cable, a failed UI board, or a defective main control board. The washer display may go blank or show garbled information.
Alternate codes: F2E2
Step-by-step fix
4 stepsPower cycle the washer
Unplug the washer for 5 minutes to allow the electronics to fully reset, then restore power and check if the error clears.
A temporary communication glitch can sometimes be resolved with a simple power cycle.
Check the ribbon cable
Remove the top panel and locate the ribbon cable connecting the user interface board to the main control board. Ensure it is firmly seated at both ends.
The ribbon cable can work loose from vibration during spin cycles.
Inspect for moisture
Look for signs of water intrusion on either control board. Moisture on the connectors or board surfaces can cause communication failures.
If moisture is found, dry the area thoroughly and check the top seal for leaks.
Replace the user interface board
If the ribbon cable is secure and dry, the UI board itself may be faulty. Replace it and test the washer.
If replacing the UI board does not fix the issue, the main control board may be at fault.
When to call a professional
If you have replaced the UI board and the error persists, a technician can diagnose whether the main control board or wiring harness is the root cause.
Related error codes
Information compiled from manufacturer service manuals, official troubleshooting documentation, and appliance repair industry resources. This guide is for informational purposes only — always consult a qualified technician for complex repairs.
Learn more about our sourcesParts you may need
Links may earn us a commission at no extra cost to you. We only recommend parts relevant to this repair.