Maytag Washer Error Code F2 E1 — Stuck Button on Control Panel
What this means
The F2 E1 error code indicates the control board has detected a button on the user interface that is stuck in the pressed position. This can be caused by physical debris, moisture under the touchpad, or a failed membrane keypad. The washer will not accept new cycle commands until the stuck button condition is cleared.
Alternate codes: F2E1
Step-by-step fix
4 stepsPress and release all buttons
Gently press and release each button on the control panel to check if any feel physically stuck. Clean around button edges with a soft cloth.
Sticky residue from detergent or softener is a common cause of stuck buttons.
Power cycle the washer
Unplug the washer for 5 minutes to reset the control electronics. Plug it back in and check if the error clears.
If moisture caused the issue, leaving the washer unplugged longer allows it to dry out.
Clean the control panel
Use a slightly damp cloth with rubbing alcohol to clean around and between all buttons. Do not spray directly on the panel.
Avoid using excessive water, which can worsen moisture-related issues.
Replace the user interface board
If the error persists after cleaning and resetting, the membrane keypad or user interface control board may need replacement.
Order the part specific to your model — the UI board varies between front-load and top-load models.
When to call a professional
If cleaning and resetting do not resolve the issue, a technician can determine whether the user interface board or the main control board needs replacement.
Related error codes
Information compiled from manufacturer service manuals, official troubleshooting documentation, and appliance repair industry resources. This guide is for informational purposes only — always consult a qualified technician for complex repairs.
Learn more about our sourcesParts you may need
Links may earn us a commission at no extra cost to you. We only recommend parts relevant to this repair.