Maytag Washer Error Code F1 E2 — Motor Control Board Error
What this means
The F1 E2 error code indicates a problem with the motor control unit (MCU), which manages the drive motor speed and direction. This can be caused by a faulty MCU board, loose wiring connections between the MCU and main control board, or a failed drive motor. The washer will stop mid-cycle when this error occurs.
Alternate codes: F1E2
Step-by-step fix
4 stepsPower cycle the washer
Unplug the washer for 5 minutes, then plug it back in. Run a test cycle to see if the error clears.
If the code appeared only once, a power cycle may resolve a temporary communication glitch.
Check MCU wiring connections
Access the motor control unit at the bottom of the washer. Inspect all wire harness connections between the MCU and the main control board. Reseat any loose connectors.
Look for signs of moisture on connectors — water leaks can cause intermittent MCU errors.
Test the drive motor
Use a multimeter to check the drive motor windings for proper resistance. Compare readings to the specifications in your service manual.
A shorted motor winding can damage the MCU board.
Replace the motor control unit
If wiring is intact and the motor tests good, replace the MCU board. Disconnect all harnesses, remove mounting hardware, and install the new unit.
Ensure the new MCU is compatible with your specific model number.
When to call a professional
If you are unsure about testing motor windings or replacing electronic control boards, a professional technician can diagnose whether the MCU or the drive motor is the root cause.
Related error codes
Information compiled from manufacturer service manuals, official troubleshooting documentation, and appliance repair industry resources. This guide is for informational purposes only — always consult a qualified technician for complex repairs.
Learn more about our sourcesParts you may need
Links may earn us a commission at no extra cost to you. We only recommend parts relevant to this repair.