Maytag Washer Error Code F1 E1 — Main Control Board Failure
What this means
The F1 E1 error code indicates the main electronic control board (Appliance Control Unit) has detected an internal memory corruption or hardware fault. This is commonly triggered by electrical surges, voltage spikes, or a degraded control board. The washer will not operate until the issue is resolved.
Alternate codes: F1E1
Step-by-step fix
4 stepsPower cycle the washer
Unplug the washer from the outlet or turn off the circuit breaker for 5 full minutes, then restore power. This allows the control board to fully reset.
Wait the full 5 minutes — shorter resets may not clear memory corruption.
Check for loose wiring
Remove the top panel and inspect all wire harness connections to the main control board. Look for burnt or corroded connectors and reseat any loose plugs.
Take a photo of all connections before disconnecting anything for reference.
Inspect the control board
Visually examine the main control board for burn marks, damaged solder joints, or swollen capacitors. These are signs of electrical surge damage.
A magnifying glass helps spot hairline cracks on the circuit board.
Replace the main control board
If the error returns after a power reset, the control board must be replaced. Remove the mounting screws, disconnect all wire harnesses, and install the new board.
Use a surge protector on the washer outlet to prevent future damage.
When to call a professional
If you are not comfortable working with electronic control boards or the replacement board also throws the same error, call a professional technician.
Related error codes
Information compiled from manufacturer service manuals, official troubleshooting documentation, and appliance repair industry resources. This guide is for informational purposes only — always consult a qualified technician for complex repairs.
Learn more about our sourcesParts you may need
Links may earn us a commission at no extra cost to you. We only recommend parts relevant to this repair.