Maytag Dishwasher Error Code F2 E2 — User Interface Communication Failure
What this means
The F2 E2 error code indicates a communication failure between the user interface (UI) panel and the main control board. This can be caused by a faulty ribbon cable, a failed UI panel, moisture intrusion, or a defective main control board. The dishwasher may display garbled information or not respond to button presses.
Alternate codes: F2E2
Step-by-step fix
4 stepsPower cycle the dishwasher
Turn off the circuit breaker for 5 minutes, then restore power. This clears temporary communication glitches.
Wait the full 5 minutes for a complete reset.
Check for moisture
Open the dishwasher door and inspect the top edge where the control panel meets the door. Look for signs of steam or moisture that may have reached the electronics.
A failing door seal can allow steam to reach the control board.
Inspect the ribbon cable
Remove the inner door panel screws and carefully open the door assembly to access the ribbon cable connecting the UI panel to the main board. Reseat the cable.
Be very careful not to damage the ribbon cable — it is fragile and expensive to replace.
Replace the UI panel
If the ribbon cable is intact and the error persists, the user interface panel is likely faulty. Remove the old panel and install the replacement, reconnecting all cables.
If replacing the UI panel does not fix the issue, the main control board may be at fault.
When to call a professional
If the error persists after replacing the UI panel, a technician should diagnose whether the main control board needs replacement.
Related error codes
Information compiled from manufacturer service manuals, official troubleshooting documentation, and appliance repair industry resources. This guide is for informational purposes only — always consult a qualified technician for complex repairs.
Learn more about our sourcesParts you may need
Links may earn us a commission at no extra cost to you. We only recommend parts relevant to this repair.