Electrolux Washer Error Code E41 — Door Lock Error
What this means
The E41 error code on Electrolux washers indicates the door lock mechanism has failed to lock, or the control board is not receiving the lock confirmation signal. The washer will not start a cycle without a confirmed door lock. Common causes include a faulty door lock assembly, damaged wiring, a misaligned door strike, or debris preventing the door from closing completely.
Alternate codes: E 41
Step-by-step fix
4 stepsCheck for door obstructions
Open and close the washer door firmly. Look for any clothing, debris, or detergent buildup that might prevent the door from closing flush against the frame. Clean the door strike and latch area.
A small sock or piece of clothing caught in the door seal is a surprisingly common cause.
Power cycle the washer
Unplug the washer from the outlet for 2 minutes, then plug it back in. Try starting a cycle. Intermittent electrical glitches can trigger the E41 code.
After plugging back in, wait 30 seconds before attempting to start a cycle.
Test the door lock assembly
Remove the front top panel to access the door lock. Disconnect the wiring connector and test the lock solenoid and switch contacts with a multimeter. The solenoid should show 800–1,200 ohms of resistance.
Also check for burn marks on the wiring connector — a loose connection can cause arcing and melting.
Replace the door lock if faulty
If the lock solenoid or switch contacts fail the multimeter test, replace the entire door lock assembly. Reconnect the wiring, reassemble, and run a test cycle.
After replacement, run the washer empty through a quick wash cycle to confirm proper operation.
When to call a professional
If the door lock assembly tests fine but the E41 persists, the control board may have a faulty triac circuit for the door lock and should be inspected by a professional.
Related error codes
Information compiled from manufacturer service manuals, official troubleshooting documentation, and appliance repair industry resources. This guide is for informational purposes only — always consult a qualified technician for complex repairs.
Learn more about our sourcesParts you may need
Door Lock Assembly
Part #137353300 · $40–$75
If lock solenoid or switch fails multimeter test
Links may earn us a commission at no extra cost to you. We only recommend parts relevant to this repair.