Amana Oven Error Code F1 E1 — Control Board Failure
What this means
Error code F1 E1 indicates the electronic range control has an internal hardware failure. The watchdog circuit on the board has detected that the microprocessor is not functioning correctly. This typically means the control board must be replaced.
Alternate codes: F1E1
Step-by-step fix
3 stepsPower cycle the oven
Turn off the circuit breaker for 5 minutes, then restore power and press Cancel. Sometimes a power surge causes a temporary watchdog trip.
If the error appeared during a thunderstorm or power outage, a reset may clear it.
Check for error persistence
If the F1 E1 code returns after the power cycle, the control board has a permanent internal failure.
Note any other error codes that appear — a technician will need this information.
Replace the electronic range control
The ERC board is located behind the oven's control panel. Remove the panel, disconnect the wiring harnesses, and install the new board.
Take photos of all wire connections before disconnecting — the replacement board must be wired identically.
When to call a professional
Control board replacement is recommended as a professional repair due to the cost of the part and the importance of correct wiring.
Related error codes
Information compiled from manufacturer service manuals, official troubleshooting documentation, and appliance repair industry resources. This guide is for informational purposes only — always consult a qualified technician for complex repairs.
Learn more about our sourcesParts you may need
Electronic Range Control (ERC)
Part #WPW10348712 · $150–$300
If board has internal failure
Links may earn us a commission at no extra cost to you. We only recommend parts relevant to this repair.