Amana Oven Error Code F1 — Electronic Oven Control (EOC) Board Failure
What this means
The F1 error code on Amana ovens indicates the Electronic Oven Control (EOC) board has detected a fault in its own internal circuitry. This is one of the most common Amana oven error codes and typically means the control board is failing or has been damaged by a power surge. The oven may stop heating, display erratic behavior, or beep continuously until the error is acknowledged.
Alternate codes: F1 E0
Step-by-step fix
4 stepsReset the oven
Turn off the circuit breaker for the oven for 5 minutes. Restore power and see if the error clears. A power surge or transient can sometimes trigger a false F1 code. If the oven operates normally, the issue may have been a one-time event.
If you experience frequent power fluctuations, consider installing a surge protector on the oven circuit.
Check the oven temperature sensor
Although F1 usually points to the EOC board, a shorted temperature sensor can sometimes cause this code. Unplug the oven or turn off the breaker. Locate the sensor probe inside the oven (a thin metal rod, usually at the top rear). Disconnect its wires and measure resistance. At room temperature, it should read approximately 1,080 to 1,100 ohms.
If the sensor reads 0 ohms (shorted) or OL (open), it is defective and could be sending bad data to the board.
Inspect the EOC board connections
Remove the back panel or the control panel cover to access the EOC board. Check all wire connectors for signs of heat damage, corrosion, or loose pins. Reseat each connector firmly.
Look closely at the board itself for burned components, bulging capacitors, or darkened solder joints — these are clear signs of board failure.
Replace the EOC board if necessary
If the sensor is good and the board shows visible damage or the error returns after reset, replace the EOC board. Transfer any overlay or bracket from the old board to the new one. Reconnect all wires and test the oven.
Write down the model and serial number from the oven rating plate before ordering the replacement board.
When to call a professional
If you are not comfortable working near high-voltage oven wiring (240V), have a professional handle the EOC board replacement. Incorrect wiring can be dangerous.
Information compiled from manufacturer service manuals, official troubleshooting documentation, and appliance repair industry resources. This guide is for informational purposes only — always consult a qualified technician for complex repairs.
Learn more about our sourcesParts you may need
Electronic Oven Control (EOC) Board
Part #W10340304 · $120–$250
If the board shows visible damage or the error persists after sensor and connection checks
Links may earn us a commission at no extra cost to you. We only recommend parts relevant to this repair.