Whirlpool Dishwasher Error Code F10 E1 — Drying Fan Motor Error
What this means
The F10 E1 error code appears on newer Whirlpool dishwashers equipped with a fan-assisted drying system. The control board has detected that the drying fan motor is not operating as expected — either not starting, running too slowly, or drawing excessive current. Without the drying fan, dishes will remain wet at the end of the cycle.
Alternate codes: F10E1
Step-by-step fix
3 stepsPower cycle and test a dry cycle
Turn off the circuit breaker for 5 minutes, restore power, and run a heated dry cycle. Listen for the drying fan — it is usually located inside the door or the upper right area of the tub.
If you hear the fan running but the code still appears, the speed sensor on the motor may be faulty.
Check the fan for obstructions
Access the drying fan by removing the inner door panel or the side panel where the fan is mounted. Check for debris blocking the fan blades and ensure the fan spins freely by hand.
Small items like utensils or broken dish pieces can sometimes fall into the fan area.
Test and replace the drying fan motor
Disconnect the fan motor wires and test for continuity. If the motor tests open or the fan does not spin when directly powered, replace the motor. Remove the mounting hardware, swap in the new motor, and reconnect.
Ensure the replacement motor is the correct model — fan motors have specific voltages and speeds.
When to call a professional
If the fan motor tests good but the error persists, the control board's fan driver circuit may need professional diagnosis.
Information compiled from manufacturer service manuals, official troubleshooting documentation, and appliance repair industry resources. This guide is for informational purposes only — always consult a qualified technician for complex repairs.
Learn more about our sourcesParts you may need
Links may earn us a commission at no extra cost to you. We only recommend parts relevant to this repair.