Maytag Oven Error Code F5 E1 — Door Lock Will Not Lock
What this means
The F5 E1 error on Maytag ovens indicates the door lock motor attempted to lock the door for a self-clean cycle but did not reach the fully locked position within the allowed time. Common causes include a jammed lock mechanism, a failed lock motor, a broken lock rod, or a misaligned door.
Alternate codes: F5E1
Step-by-step fix
4 stepsReset the oven
Press Cancel. Turn off the circuit breaker for 5 minutes, then restore power. Try starting the self-clean cycle again.
Sometimes the lock motor glitches during its travel. A power reset resets the motor position.
Check the door lock mechanism
Remove the screws from the top panel or control panel rear to access the lock assembly. Verify that the lock rod or cam moves freely without binding. Check for bent or broken linkage.
Apply a small amount of high-temperature grease to the lock rod pivot points if movement is stiff.
Test the lock motor
Disconnect the lock motor wires and test for continuity. If it reads open, the motor winding has failed.
You can also try manually actuating the lock by turning the motor shaft with a flat screwdriver to check for mechanical binding.
Replace the lock motor assembly
If the motor is faulty or the mechanism is damaged, replace the entire lock assembly. Install the new assembly, reconnect wiring, and test the self-clean cycle.
After installing, run the lock through a cycle without heating to verify it locks and unlocks smoothly.
When to call a professional
If the lock motor and mechanism are fine but the control board does not send the lock signal, professional diagnosis of the control board is needed.
Information compiled from manufacturer service manuals, official troubleshooting documentation, and appliance repair industry resources. This guide is for informational purposes only — always consult a qualified technician for complex repairs.
Learn more about our sourcesParts you may need
Door Lock Motor Assembly
Part #W10107820 · $35–$60
If motor fails continuity or mechanism is jammed
Links may earn us a commission at no extra cost to you. We only recommend parts relevant to this repair.