Maytag Oven Error Code F2 E0 — Oven Temperature Sensor Shorted
What this means
The F2 E0 error on Maytag ovens indicates the oven temperature sensor (RTD) has a short circuit, meaning its resistance is abnormally low. The control board cannot accurately monitor oven temperature with a shorted sensor, so it shuts down the heating elements. Common causes include a physically damaged sensor probe, moisture on the sensor connections, or a pinched wire in the sensor harness.
Alternate codes: F2E0
Step-by-step fix
3 stepsTest the temperature sensor
Turn off the circuit breaker. Access the oven temperature sensor wires — either at the sensor connector inside the oven cavity or at the control board. Measure resistance at room temperature. It should read approximately 1,080–1,100 ohms. A reading near 0 ohms confirms a short.
Test at the sensor connector and again at the control board connector to isolate whether the short is in the sensor or the wiring.
Inspect the sensor and wiring
Look at the sensor probe inside the oven for physical damage — cracks, corrosion, or bent mounting. Also inspect the wiring harness for pinched or melted insulation that could cause the wires to touch.
Oven cleaners can corrode sensor connections if sprayed near the sensor probe.
Replace the sensor or repair the wiring
If the sensor reads near 0 ohms, replace it. Remove the mounting screw, disconnect the old sensor, and install the new one. If the sensor reads correctly but the wiring shorts, repair or replace the affected wire segment.
Route the replacement sensor wires away from the oven vent area to prevent heat damage.
When to call a professional
If both the sensor and wiring test correctly but the error persists, the control board may have a faulty sensor input circuit.
Information compiled from manufacturer service manuals, official troubleshooting documentation, and appliance repair industry resources. This guide is for informational purposes only — always consult a qualified technician for complex repairs.
Learn more about our sourcesParts you may need
Links may earn us a commission at no extra cost to you. We only recommend parts relevant to this repair.