LG Styler Error Code AE — Compressor Alignment Error
What this means
The AE error code on the LG Styler indicates a compressor alignment error. This can occur when the compressor's internal components are not properly aligned after shipment, installation, or if the unit has been moved or tilted. The compressor may also throw an AE code if its mounting hardware has loosened, causing vibration-induced misalignment. In some cases, AE can indicate the early stages of a compressor failure where internal mechanical components are wearing unevenly.
Step-by-step fix
4 stepsLet the Styler settle
If the Styler was recently moved, transported, or tilted, allow it to sit upright and undisturbed for at least 4 hours before attempting to run a cycle. This allows refrigerant oil to settle back into the compressor.
If the Styler was delivered on its side, wait 24 hours before plugging it in.
Ensure the Styler is level
Check that the Styler is standing perfectly level on a solid, flat surface. Use a bubble level on top of the unit. Adjust the leveling feet if needed.
An unlevel Styler can cause the compressor to vibrate excessively and trigger AE.
Power-reset the Styler
Unplug the Styler for 10 minutes, then plug it back in and start a cycle. If the compressor was temporarily misaligned due to vibration, a reset may clear the code.
Contact LG service
If AE persists, the compressor mounting or internal components need professional inspection. Do not continue using the Styler with a persistent AE code.
When to call a professional
If the AE code persists after settling, leveling, and a power reset, a technician should inspect the compressor mounting hardware and internal alignment. Continued use with AE can lead to permanent compressor damage.
Related error codes
Information compiled from manufacturer service manuals, official troubleshooting documentation, and appliance repair industry resources. This guide is for informational purposes only — always consult a qualified technician for complex repairs.
Learn more about our sourcesParts you may need
Compressor Mounting Hardware Kit
Part #N/A (model-specific) · $15–$30
If mounting bolts or grommets have loosened
Links may earn us a commission at no extra cost to you. We only recommend parts relevant to this repair.