Hotpoint Oven Error Code F2 — Oven Over-Temperature
What this means
The F2 error on Hotpoint ovens indicates the oven cavity temperature has risen above the maximum safe threshold (typically 590°F during baking or 915°F during self-clean). The control board shuts off power to the heating elements to prevent damage or fire. This is commonly caused by a stuck or welded oven relay on the control board, a shorted bake or broil element, or a faulty temperature sensor giving false low readings that cause the oven to overheat.
Step-by-step fix
4 stepsTurn off the oven immediately
Press Cancel/Off. If the oven does not respond, turn off the circuit breaker. Do not open the oven door — let it cool with the door closed.
Opening the door during an over-temperature event can cause a rush of superheated air. Keep it closed until the oven has cooled.
Test the oven temperature sensor
After the oven has fully cooled, disconnect power at the breaker. Measure the sensor resistance at room temperature (should be approximately 1,080–1,100 ohms). A reading far below normal could cause the control to think the oven is cold and overheat.
Also check the sensor for physical damage — a cracked or broken sensor probe must be replaced.
Inspect the bake and broil elements
Visually check each heating element for bright spots, blisters, or holes. Test each element for continuity and for ground fault (one probe on a terminal, other on the chassis). A grounded element can run uncontrolled.
A grounded bake element is one of the most dangerous causes of oven overheating — it bypasses the control board entirely.
Check the control board relays
If the sensor and elements test fine, the relay on the EOC that controls the bake or broil circuit may be welded shut, keeping the element permanently energized. The EOC board must be replaced.
You can verify a welded relay by disconnecting the element wires — if the element wires still have voltage (use extreme caution), the relay is stuck.
When to call a professional
Due to the safety risks involved with over-temperature conditions and 240V circuits, calling a professional is strongly recommended unless you are experienced with appliance electrical repair.
Information compiled from manufacturer service manuals, official troubleshooting documentation, and appliance repair industry resources. This guide is for informational purposes only — always consult a qualified technician for complex repairs.
Learn more about our sourcesParts you may need
Links may earn us a commission at no extra cost to you. We only recommend parts relevant to this repair.