GE Washer Error Code E41 — Door Switch Malfunction
What this means
The E41 error code on GE washers indicates a malfunction in the door switch circuit. The control board cannot confirm whether the door is open or closed, so the washer will not start a cycle. This is usually caused by a faulty door switch, a broken wire in the door switch harness, or a control board issue.
Step-by-step fix
3 stepsCheck the door latch
Open and close the door firmly. Make sure it clicks and latches securely. Check for any obstructions in the door seal.
Test the door switch
Unplug the washer. Access the door switch behind the front panel. Disconnect the switch wires and test for continuity with a multimeter — the switch should show continuity when pressed (door closed) and open when released.
Replace the door switch
If the switch fails the continuity test, replace it. It's typically held in place by clips or screws. Install the new switch and reconnect the wires.
When to call a professional
If the door switch tests fine but the E41 code persists, the main control board may not be receiving the signal. A technician should check the board.
Related error codes
Information compiled from manufacturer service manuals, official troubleshooting documentation, and appliance repair industry resources. This guide is for informational purposes only — always consult a qualified technician for complex repairs.
Learn more about our sourcesParts you may need
Links may earn us a commission at no extra cost to you. We only recommend parts relevant to this repair.