Frigidaire Dishwasher Error Code i60 — Water Heating Fault
What this means
The i60 error on Frigidaire dishwashers indicates the water temperature has not risen sufficiently during the heating phase. The dishwasher requires water to reach approximately 120–140°F for proper cleaning and sanitization. Causes include a failed heating element, a tripped thermal fuse, a faulty thermistor (temperature sensor), or low incoming water temperature from the household water heater.
Alternate codes: I60
Step-by-step fix
4 stepsRun hot water before starting
Run the kitchen faucet until the water is hot before starting the dishwasher. This ensures the first fill uses hot water. Verify your water heater is set to at least 120°F.
If you have a long pipe run from the water heater, the first several gallons may be lukewarm.
Test the heating element
Disconnect power. Access the heating element terminals underneath the dishwasher tub. Disconnect the wires and test for continuity. A good element reads 10–30 ohms. Also test for ground fault.
Visually inspect the element through the bottom of the tub — look for cracks, blisters, or discoloration.
Check the thermistor
The water temperature sensor (thermistor) is usually near the sump or water inlet area. Test its resistance — at room temperature, it typically reads 10,000–15,000 ohms depending on the model.
A thermistor that reads incorrect values can confuse the control board about the actual water temperature.
Replace the faulty component
Replace the heating element if it fails continuity or the thermistor if it reads out of range. Reconnect wiring and run a hot wash cycle to verify the fix.
After replacing the element, check for leaks around the mounting hardware.
When to call a professional
If the element and thermistor are both fine, the control board heater relay may have failed — professional diagnosis is needed.
Information compiled from manufacturer service manuals, official troubleshooting documentation, and appliance repair industry resources. This guide is for informational purposes only — always consult a qualified technician for complex repairs.
Learn more about our sourcesParts you may need
Heating Element
Part #154825001 · $20–$45
If element fails continuity or ground fault test
Links may earn us a commission at no extra cost to you. We only recommend parts relevant to this repair.