Er rS

Dacor Refrigerator Error Code Er rS — Refrigerator Compartment Sensor Fault

Moderate Repair 20–40 minutes Tools: Phillips screwdriver, Multimeter

What this means

Error code Er rS on Dacor refrigerators indicates the fresh food compartment temperature sensor (thermistor) has returned a reading outside the acceptable range. This sensor monitors the main refrigerator section temperature and helps the control board regulate the compressor and damper system. A failed sensor can cause the compartment to overcool (freezing food) or undercool (food spoiling). Dacor refrigerators, built on Samsung's platform, use the same Samsung-style error code format.

Alternate codes: Er-rS, Error rS, rS error

Step-by-step fix

4 steps
1

Reset the refrigerator

Unplug the refrigerator for 5 minutes or use the button reset (hold Power Freeze + Fridge for 8 seconds). Allow 10 minutes after restoring power for the control board to take a fresh sensor reading.

If Er rS appeared after a temporary power outage, a reset often clears it permanently.

2

Locate the refrigerator sensor

Open the refrigerator door. The temperature sensor is typically located behind the air duct cover at the top or rear of the compartment. Remove the cover (usually clips or 2 screws) to access the sensor.

On Dacor column refrigerators, the sensor may be inside the evaporator housing. Check your model's tech sheet for the exact location.

3

Test the sensor

Disconnect the sensor and test resistance with a multimeter. At refrigerator temperature (37°F / 3°C), the sensor should read approximately 7,000–8,000 ohms. At room temperature (77°F / 25°C), it should read about 5,000 ohms. Significantly different readings indicate a failed sensor.

Place the disconnected sensor in a glass of ice water to simulate a known temperature and verify the reading is in the expected range.

4

Replace the sensor

If the sensor is out of specification, replace it. The sensor clips or screws into its mounting position. Route the wire along the original path and reconnect. Reassemble the cover and restore power.

Allow 24 hours after sensor replacement for the refrigerator temperature to fully stabilize.

When to call a professional

If the sensor tests fine but Er rS persists, the control board's sensor input may be faulty. A Dacor technician should verify before replacing the expensive control board.

Related error codes

Information compiled from manufacturer service manuals, official troubleshooting documentation, and appliance repair industry resources. This guide is for informational purposes only — always consult a qualified technician for complex repairs.

Learn more about our sources

Parts you may need

Refrigerator Compartment Sensor

Part #DAC-DA32-10104N · $10–$25

Required if sensor reads out of specification

Find Part

Links may earn us a commission at no extra cost to you. We only recommend parts relevant to this repair.

Quick Info

BrandDacor
ApplianceRefrigerator
Error CodeEr rS
DifficultyModerate Repair
Est. Time20–40 minutes