Dacor Refrigerator Error Code Er IF — Ice Maker Fan Fault
What this means
Error code Er IF on Dacor refrigerators (which share Samsung's premium refrigerator platform) indicates the ice maker fan motor is not operating correctly. This fan circulates cold air within the ice-making compartment to ensure consistent freezing. When the fan fails, ice production slows or stops entirely, and the control board logs this error. Causes include a seized fan motor, ice buildup blocking the fan blade, a disconnected wire harness, or a faulty fan motor.
Alternate codes: Er-IF, Error IF, IF error
Step-by-step fix
4 stepsReset the refrigerator
Press and hold the Power Freeze and Fridge buttons simultaneously for 8 seconds to reset the control board (button combination varies by model). Alternatively, unplug the refrigerator for 5 minutes. Check if the error clears.
Dacor refrigerators built on the Samsung platform use Samsung-style reset procedures. Check your model's manual for the exact button combination.
Check for ice buildup on the fan
Remove the ice maker assembly or the panel behind the ice compartment to access the ice maker fan. Check for ice accumulation around the fan blade. If ice is present, use a hair dryer on low heat to carefully melt it. Ensure the fan blade spins freely once cleared.
Recurring ice buildup around this fan suggests a door seal issue or excessive humidity entering the ice compartment.
Test the fan motor
Disconnect the fan motor wiring and measure resistance with a multimeter. A working fan motor typically reads 100–500 ohms. Also try to spin the fan by hand — it should rotate smoothly without resistance.
A motor that buzzes but does not turn has a seized bearing. A motor with no response at all has an open winding.
Replace the fan motor
If the motor is faulty, remove it from its bracket (usually 2–3 screws), disconnect the wire harness, and install the new motor. Ensure the fan blade is properly attached and oriented. Reassemble and test by running the ice maker.
After replacing the fan, run the ice maker through two full cycles to confirm proper operation before reassembling all panels.
When to call a professional
If the fan and wiring test fine but Er IF persists, the control board may have a faulty fan driver output. A Dacor technician with diagnostic tools can pinpoint the issue.
Related error codes
Information compiled from manufacturer service manuals, official troubleshooting documentation, and appliance repair industry resources. This guide is for informational purposes only — always consult a qualified technician for complex repairs.
Learn more about our sourcesParts you may need
Ice Maker Fan Motor
Part #DAC-DA31-00340A · $25–$50
Required if motor is seized or has open windings
Ice Maker Assembly
Part #DAC-DA97-15217D · $80–$150
If full ice maker assembly needs replacement
Links may earn us a commission at no extra cost to you. We only recommend parts relevant to this repair.