Amana Washer Error Code F9 E1 — Long Drain Time
What this means
The F9 E1 error code means the washer cannot drain the water within 8 minutes. This is usually caused by a clogged drain pump filter, a kinked or blocked drain hose, a faulty drain pump, or an obstruction in the drain system. Items like coins, socks, and hair clips commonly lodge in the pump and cause this error.
Alternate codes: F9E1
Step-by-step fix
4 stepsCheck the drain hose
Pull the washer away from the wall and inspect the drain hose for kinks or bends. Ensure the hose is not pushed too far into the standpipe (no more than 8 inches). Check that the standpipe is not clogged.
The drain hose end should be between 39 and 96 inches above the floor for proper drainage.
Clean the drain pump filter
Locate the drain pump access panel at the bottom front of the washer. Place towels and a shallow pan underneath. Open the filter cap slowly and let water drain into the pan. Remove any debris from the filter.
Expect a significant amount of water — have extra towels on hand.
Inspect the drain pump
With the filter removed, look inside the pump housing for obstructions. Check that the pump impeller spins freely. Listen for unusual grinding noises when the pump runs.
A pump that hums but doesn't move water likely has a jammed or broken impeller.
Replace the drain pump if necessary
If the pump impeller is broken or the motor has failed, replace the entire drain pump assembly. Disconnect the hoses and electrical connector, remove mounting screws, and install the new pump.
When to call a professional
If the drain system is clear and the pump runs normally but the error persists, there may be a control board issue requiring professional diagnosis.
Information compiled from manufacturer service manuals, official troubleshooting documentation, and appliance repair industry resources. This guide is for informational purposes only — always consult a qualified technician for complex repairs.
Learn more about our sourcesParts you may need
Links may earn us a commission at no extra cost to you. We only recommend parts relevant to this repair.