Amana Washer Error Code F8 E2 — Dispenser System Error
What this means
The F8 E2 error code on Amana washers indicates a problem with the automatic detergent dispenser system. The dispenser motor may be jammed, the wiring to the dispenser may be damaged, or the control board is not receiving the expected feedback signal. This code is most common on models with an automatic dispenser feature.
Alternate codes: F8E2
Step-by-step fix
4 stepsRemove and clean the dispenser drawer
Pull out the detergent dispenser drawer completely. Wash it under warm water to remove caked detergent or fabric softener buildup that may be jamming the mechanism.
Use a small brush to clean inside the dispenser housing cavity as well.
Check the dispenser motor
Unplug the washer and access the dispenser motor behind the control panel area. Check for loose or corroded connections on the motor wiring harness.
Test the motor with a multimeter
Disconnect the motor wiring and test for continuity. The motor should show some resistance. If it reads open (infinite), the motor is burned out.
Also try manually turning the motor shaft to check for mechanical binding.
Replace the dispenser motor if faulty
Remove the mounting screws, disconnect the old motor, install the replacement, and reconnect the wiring harness. Run a test cycle to verify.
If you don't use the auto-dispense feature, you can add detergent manually to the drum as a workaround.
When to call a professional
If the dispenser motor is fine but the code persists, the control board may need professional diagnosis or replacement.
Information compiled from manufacturer service manuals, official troubleshooting documentation, and appliance repair industry resources. This guide is for informational purposes only — always consult a qualified technician for complex repairs.
Learn more about our sourcesParts you may need
Links may earn us a commission at no extra cost to you. We only recommend parts relevant to this repair.