Amana Washer Error Code F3 E1 — Pressure Switch Malfunction
What this means
The F3 E1 error code on Amana washers indicates the water level pressure switch is not providing a valid signal. This can be caused by a kinked or disconnected pressure hose, a faulty pressure switch, or a problem with the control board. The washer may fail to fill or may overfill when this code appears.
Alternate codes: F3E1
Step-by-step fix
4 stepsUnplug and access the pressure switch
Disconnect the washer from power. Remove the top panel or control console to locate the pressure switch, typically mounted near the top of the machine.
Wait at least 60 seconds after unplugging before working inside the machine.
Inspect the pressure hose
Check the small rubber hose that runs from the tub air trap to the pressure switch. Look for kinks, cracks, holes, or disconnections at either end.
Blow gently through the hose to check for blockages — you should feel slight resistance.
Test the pressure switch
Disconnect the wire harness from the pressure switch. Use a multimeter to test continuity between the switch terminals. Refer to the tech sheet for expected values.
The switch should click and change continuity when you blow into the hose.
Replace the pressure switch if faulty
Remove the mounting clip, disconnect the hose, and install the new switch. Reconnect the hose and wiring harness, then reassemble the panel.
Run a diagnostic cycle after replacement to confirm the error has cleared.
When to call a professional
If the pressure switch and hose are fine but the code returns, the main control board may be failing and needs professional diagnosis.
Information compiled from manufacturer service manuals, official troubleshooting documentation, and appliance repair industry resources. This guide is for informational purposes only — always consult a qualified technician for complex repairs.
Learn more about our sourcesParts you may need
Links may earn us a commission at no extra cost to you. We only recommend parts relevant to this repair.