Amana Washer Error Code F2 E1 — Stuck Key on User Interface
What this means
The F2 E1 error on Amana washers means the user interface (UI) board detects a key being pressed for longer than 15 seconds. This is usually caused by a physically stuck button, moisture under the control panel overlay, or a faulty UI board. The washer will not respond to other button presses until this is resolved.
Alternate codes: F2E1
Step-by-step fix
4 stepsTry to free the stuck button
Press each button on the control panel firmly and release. Look for any button that feels different or does not spring back. Gently press around the edges of the stuck button to free it.
Spilled liquid or detergent can seep under buttons and cause them to stick.
Power cycle the washer
Unplug the washer for 5 minutes, then plug it back in. If the code clears, the button may have been temporarily stuck.
Clean the control panel
Wipe down the control panel with a slightly damp cloth. If the panel overlay is peeling or bubbling, moisture may be trapped underneath causing phantom button presses.
Do not use excessive water or spray cleaners directly on the panel.
Replace the user interface board
If the code persists, the UI board behind the control panel may need replacement. Remove the control console, disconnect the UI board, and install the replacement.
Be careful with the ribbon cable connector — it is fragile.
When to call a professional
If replacing the UI board does not fix the issue, the main control board may have a communication fault and needs professional diagnosis.
Information compiled from manufacturer service manuals, official troubleshooting documentation, and appliance repair industry resources. This guide is for informational purposes only — always consult a qualified technician for complex repairs.
Learn more about our sourcesParts you may need
Links may earn us a commission at no extra cost to you. We only recommend parts relevant to this repair.