Amana Washer Error Code dL — Door Lock Error
What this means
The dL error code on Amana washers means the lid lock mechanism (top-load) or door lock (front-load) failed to engage. The washer will not start or will stop mid-cycle for safety. This may be caused by a misaligned lid, a broken lid lock switch, a damaged lock striker, or a wiring issue to the lock assembly.
Alternate codes: DL, dl, F5 E1
Step-by-step fix
4 stepsCheck the lid/door alignment
Close the lid or door firmly and make sure it is aligned properly with the lock striker. Check for any warping, bent hinges, or obstructions preventing a flush close.
On top-load models, the lid must press down on the lock switch firmly.
Inspect the lid lock mechanism
Unplug the washer and access the lid lock assembly. On top-loaders, it is under the top panel near the front. Check for visible damage, broken plastic tabs, or burnt marks.
The lock should click audibly when engaged — if there's no click, the mechanism is likely broken.
Test the lid lock electrically
Disconnect the wire harness from the lid lock. Test the lock switch for continuity with a multimeter. There should be continuity when the lock is engaged and none when open.
Replace the lid lock assembly
If the lock mechanism fails testing, remove the mounting screws and disconnect the wiring. Install the new lid lock, reconnect the harness, and test.
After replacing, run a short cycle to verify the lock engages and disengages properly.
When to call a professional
If the lid lock assembly is new and the error persists, the main control board or its wiring harness may need professional inspection.
Information compiled from manufacturer service manuals, official troubleshooting documentation, and appliance repair industry resources. This guide is for informational purposes only — always consult a qualified technician for complex repairs.
Learn more about our sourcesParts you may need
Lid Lock Assembly
Part #W10404050 · $25–$50
If lock mechanism is broken or fails electrically
Links may earn us a commission at no extra cost to you. We only recommend parts relevant to this repair.