Amana Dryer Error Code F1 E1 — Main Control Board Failure
What this means
The F1 E1 error code on Amana dryers indicates the main control board has experienced an internal error, such as a memory fault or communication failure. Power surges, moisture, and aging components are common causes. A power cycle may temporarily clear the code, but if it recurs, the board usually needs replacement.
Alternate codes: F1E1
Step-by-step fix
4 stepsPower cycle the dryer
Unplug the dryer for 5 minutes or turn off the breaker. Plug it back in and try starting a cycle.
This clears temporary glitches caused by power surges.
Check wiring connections to the control board
Unplug the dryer and remove the top panel or back panel to access the control board. Inspect all wire harness connectors for loose, corroded, or burnt connections. Reseat each connector.
Vibration from the dryer can loosen connections over time.
Inspect the control board visually
Look at the circuit board for burned components, darkened areas, bulging capacitors, or signs of moisture damage.
Take a photo of all connector positions before removing any wires.
Replace the control board
If the code persists after reseating connectors, replace the main control board. Transfer all connectors to the new board in the same positions.
Use a surge protector after installation to protect the new board.
When to call a professional
If you are not comfortable working with electronic control boards, or if a new board does not fix the issue, call a professional.
Information compiled from manufacturer service manuals, official troubleshooting documentation, and appliance repair industry resources. This guide is for informational purposes only — always consult a qualified technician for complex repairs.
Learn more about our sourcesParts you may need
Main Control Board
Part #W11537215 · $100–$200
If code persists after power cycle and connector check
Links may earn us a commission at no extra cost to you. We only recommend parts relevant to this repair.